Yamaha AX-892 Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Yamaha AX-892. Yamaha AX-892 24 pagina's. Natural sound stereo amplifier

Pagina afdrukken

CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.

To assure the finest performance, please read this manual

carefully and keep it in a safe place for future use.

Install this unit in a cool, dry and dust-free area. Do not place it in

direct sunlight or near sources of heat (e.g., a stove, etc.). Make

sure that it is well ventilated and not exposed to rain or moisture

and that it is on a flat, stable surface, free from vibration.

Never open the cabinet. If something drops into the unit, contact

your dealer.

When moving the unit, first disconnect the AC power plug and the

cables which are connected to other equipment. Never pull the

cables or use excessive force on switches or controls.

The openings on the cabinet assure proper ventilation of the unit.

If these openings are obstructed, the temperature inside the

cabinet will rise rapidly, damaging the unit or causing a fire. Avoid

blocking the ventilation openings and make sure that the unit is

well ventilated. Allow at least 30 cm (12 in) of space above the

unit and 20 cm (8 in) of space on the sides and rear.

Always set the VOLUME control to " ∞ " before playing the source.

Increase the volume gradually to a desired level after the source

has started playing.

Use a clean, dry cloth to clean the unit. Do not use chemical

solvents which might damage the finish.

Be sure to read the "TROUBLESHOOTING" section before

deciding that the unit is faulty.

When not planning to use this unit for long periods of time (e.g.,

vacation, etc.), disconnect the AC power plug from the electrical

outlet.

10.

To prevent damage from lightning, disconnect the AC power plug

and antenna cable when there is an electrical storm.

11.

Make sure that the unit is always properly grounded and

polarized.

12.

Do not connect audio equipment to the AC outlet on the rear panel

if the equipment requires more power than the outlet is rated to

provide.

WARNING

Do not change the IMPEDANCE SELECTOR

switch setting while the power to this unit is on,

otherwise this unit may be damaged.

IF THIS UNIT FAILS TO TURN ON WHEN THE

POWER SWITCH IS PRESSED

The IMPEDANCE SELECTOR switch may not be

set to either end closely. If so, set the switch to

either end closely.

13.

Voltage Selector (General Model only)

The voltage selector on the rear panel of this unit must be set

for your local main voltage

outlet.

Voltages are 110/120/220/240 V AC, 60/50 Hz.

WARNING

To reduce the risk of fire or electric shock, do not expose the unit to

rain or moisture.

IMPORTANT

The serial number is located on the rear panel.

Please record the serial number of this unit in the space below.

Serial No.:

Keep this Owner's Manual in a safe place for future use.

Note

The unit is not disconnected from the AC power source as long as it

is connected to the electrical outlet, even if the unit itself is turned

off.

CAUTION (FOR CANADA MODEL)

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF

PLUG TO WIDE SLOT AND FULLY INSERT.

FOR CANADIAN CUSTOMERS

THIS CLASS B DIGITAL APPARATUS MEETS ALL

REQUIREMENTS OF THE CANADIAN INTERFERENCE-

CAUSING EQUIPMENT REGULATIONS.

VOLTAGE SELECTOR

IMPEDANCE

SELECTOR

AC OUTLETS

SWITCHIED

100W MAX. TOTAL

A OR B : 4 MIN. /SPEAKER

A + B : 8 MIN. /SPEAKER

A OR B : 6 MIN. /SPEAKER

A + B :12 MIN. /SPEAKER

before plugging into the electrical

Example: AX-892