Yamaha TX4n Gebruikershandleiding - Pagina 11
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Yamaha TX4n. Yamaha TX4n 24 pagina's. Txn series
Ook voor Yamaha TX4n: Specificaties (4 pagina's), Gebruikershandleiding (24 pagina's), Gebruikershandleiding (24 pagina's), Gebruikershandleiding (24 pagina's), Gebruikershandleiding (24 pagina's)
Pagina afdrukken
Audio I/O Settings
The TXn can be operated in one of three audio input/output modes: Stereo mode, Parallel mode, or Bridge mode.
Make audio input/output connections and settings as follows.
• With the factory settings, if both analog and digital (input from the slot) signals are input simultaneously, the two signal will be
NOTE
mixed and output. This setting can be changed from the panel of the TXn or via Amp Editor. For details on making this setting,
refer to "TX6n/5n/4n Reference Manual" or "Amp Editor Owner's Manual."
• Use 110-ohm AES/EBU digital cables for digital audio connections. Using analog cables may degrade the sonic quality.
Stereo Mode
Channels A and B (analog) or channels 1 and 2 (digital) will
operate independently in stereo.
5-way binding post connectors
+
+
–
–
Total speaker
Total speaker
impedance:
impedance:
2–8Ω
2–8Ω
Speakon connectors
Total speaker
Total speaker
impedance:
impedance:
2–8Ω
2–8Ω
• Each of 5-way binding post connectors and Speakon
NOTE
connectors are internally parallel-connected. When
using both connectors simultaneously, total speaker
impedance of each connector must be 4–16 Ω.
Analog input
Digital input
Analog input
Digital input
Parallel Mode
The amplifier will operate as a two-channel monaural amp,
with the input signal of channel A (analog) or channel 1
(digital) as the source. Channel B (analog) and channel 2
(digital) will not be used.
5-way binding post connectors
–
+
+
–
Total speaker
Total speaker
impedance:
impedance:
2–8Ω
2–8Ω
Digital input
Speakon connectors
Total speaker
Total speaker
impedance:
impedance:
2–8Ω
2–8Ω
Digital input
• Each of 5-way binding post connectors and Speakon
NOTE
connectors are internally parallel-connected. When
using both connectors simultaneously, total speaker
impedance of each connector must be 4–16 Ω.
Analog input
Analog input
11
TX6n/5n/4n Owner's Manual