aerauliqa Quantum EX 100 HT Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} aerauliqa Quantum EX 100 HT. aerauliqa Quantum EX 100 HT 16 pagina's.

Pagina afdrukken

Read this manual carefully before using the product and keep it in a safe place for reference.

This product was constructed up to standard and in compliance with regulations relating

to electrical equipment and must be installed by technically qualified personnel.

The manufacturer assumes no responsibility for damage to persons or property resulting

from failure to observe the regulations contained in this booklet.

PRECAUTIONS FOR INSTALLATION, USE AND MAINTENANCE

• The device should not be used for applications other than those speciﬁed in this manual.

• After removing the product from its packaging, verify its condition. In case of doubt,

contact a qualiﬁed technician. Do not leave packaging within the reach of small

children or people with disabilities.

• Do not touch the appliance with wet or damp hands/feet.

• This appliance can be used by children aged from 8 years and above and persons

with reduced physical, sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved. Children shall not play

with the appliance. Cleaning and user maintenance shall not be made by children

without supervision.

• Do not use the product in the presence of flammable vapours, such as alcohol,

insecticides, gasoline, etc.

• If any abnormalities in operation are detected, disconnect the device from the mains

supply and contact a qualiﬁed technician immediately. Use original spare parts only

for repairs.

• The electrical system to which the device is connected must comply with regulations.

• Before connecting the product to the power supply or the power outlet, ensure that:

- the data plate (voltage and frequency) correspond to those of the electrical mains

- the electrical power supply/socket is adequate for maximum device power. If not,

contact a qualiﬁed technician.

• The device should not be used as an activator for water heaters, stoves, etc., nor

should it discharge into hot air/fume vent ducts deriving from any type of combustion

unit. It must expel air outside via its own special duct.

• Operating temperature: 0°C up to +40°C.

• The device is designed to extract clean air only, i.e. without grease, soot, chemical or

corrosive agents, or flammable or explosive mixtures.

• Do not leave the device exposed to atmospheric agents (rain, sun, snow, etc.).

• Do not immerse the device or its parts in water or other liquids.

• Turn off the main switch whenever a malfunction is detected or when cleaning.

• For installation an omnipolar switch should be incorporated in the ﬁxed wiring, in

accordance with the wiring regulations, to provide a full disconnection under overvoltage

category III conditions (contact opening distance equal to or greater than 3mm).

• If the supply cord is damaged, it must be replaced by the manufacturer, its service

agent or similarly qualiﬁed persons in order to avoid a hazard.

• Do not obstruct the fan or exhaust grille to ensure optimum air passage.

• Ensure adequate air return into the room in compliance with existing regulations in

order to ensure proper device operation.

• If the environment in which the product is installed also houses a fuel-operating

device (water heater, methane stove etc., that is not a "sealed chamber" type), it

is essential to ensure adequate air intake, to ensure good combustion and proper

equipment operation.