Yamaha HS8I Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Yamaha HS8I. Yamaha HS8I 20 pagina's. Powered studio monitor and powered subwoofer
Ook voor Yamaha HS8I: Gebruikershandleiding (20 pagina's), Gebruikershandleiding (20 pagina's), Gebruikershandleiding (20 pagina's), Gebruikershandleiding (20 pagina's), Gebruikershandleiding (20 pagina's)

Pagina afdrukken

 Point 2

Position the left and ri ht speakers

symmetrically.

The left and right speakers should be positioned as

symmetrically as possible in relation to the room. In

other words, the left and right speakers should be the

same distance from the rear wall and the respective left

and right walls.

 Point 3

The optimum listenin position is at the apex of

an equilateral trian le.

For the most accurate sound and balance, position

yourself at the apex of an equilateral triangle formed by

the left and right speakers and yourself, with the

speakers angled inward so that they're facing you.

 Point 4

Position the tweeters at ear hei ht.

High frequencies are quite directional, so for the most

accurate monitoring the speakers should be set up so

that the tweeters are at approximately the same height

as your ears when you're seated at the listening

position.

HS8/HS7/HS5 Settin s

Once the physical layout of your monitor system is

finalized, you can begin making the following settings.

Turn the level/volume controls on all

source equipment (audio interface, etc.) all

the way down.

Set the HS8/HS7/HS5 LEVEL control to the

12-o'clock position, and set both ROOM

CONTROL and HIGH TRIM switches to 0

dB.

Turn the power to connected audio source

devices on first, and then turn on power to

the speakers.

NOTICE

When turning power off, turn off the speakers first, and then turn

off connected audio source devices.

Play some source material and radually

raise the level/volume controls on the

source equipment.

NOTICE

Be careful not to suddenly apply an excessively loud signal to the

system. Excessive level can damage the speakers.

Set the listenin level to a level at which

you can listen comfortably without fati ue

for an extended period of time.

HS8/HS7/HS5/HS8I/HS7I/HS5I/HS8S Owner's Manual

NOTE If necessary, adjust the ROOM CONTROL and HIGH TRIM

switches for the most natural response (refer to page 6).

Addin a Subwoofer (HS8S)

Adding a subwoofer to your monitor system can

significantly improve its low-frequency fidelity, making it

possible to create better overall mixes.

The subwoofer is normally placed on the floor between

the left and right full-range speakers, but since the

subwoofer reproduces low frequencies below 200 Hz

that are relatively non-directional, subwoofer positioning

is not critical.

Four cables are required: two to connect the audio

interface or other source equipment to the HS8S

subwoofer, and two more to connect the subwoofer to

the left and right HS8/HS7/HS5 main speakers.

The connections are made as shown below.

HS /HS7/HS5

HS S

Audio interface or

other source

NOTICE

Plug the supplied AC power cord into the corresponding socket on the

speaker. Plug the power cord into the speaker first, and then insert the

AC plug end into an appropriate AC wall outlet.

HS S

HS /HS7/HS5