Directechs PKUCH2GX Installatiehandleiding

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Directechs PKUCH2GX. Directechs PKUCH2GX 3 pagina's. Chrysler 1st & 2nd generation sentry key override with 2nd start activation output

Pagina afdrukken

PKUCH2GX

Description:

Chrysler 1st & 2nd Generation Sentry Key Override with 2nd Start Activation Output (

Functions:

Transponder Bypass Kit for 1st & 2nd generation encrypted Chrysler Sentry key immobilizer systems. This transponder

bypass kit will override all Chrysler, Dodge & Jeep vehicles equipped with the 1st & 2nd generation type of Sentry

transponder key. PKUCH2GX designed with MUX (2nd starter & accessory wire) activation output

Starter & 2nd accessory wire during start up.

Generation

Connector

Brown

Ground When Running (-) (remote Start Installations Only)

Green

N/C

Blue

N/C

Violet/White

Data Ouput To Violet/brown 2nd Start Wire (Wire Located In The Steering Column)

Violet

12 Volt Starter Input To Remote Starter (Wire In Parallel With Vehicle Start Wire)

Pink/White

Disarm Input (Connect To The Disarm Output From Remote System)

Pink

Ignition Input To Vehicle (Connect To Main Ignition Of Vehicle)

Orange

N/C

Red

(+)12 Volt Constant

Black

Chassis Ground

You will need 2 valid keys. Proceed as follows:

1-Insert first key and turn to the IGN "ON" position: "THEFT" light will turn ON, then go "OFF". Remove the first key.

2- Within 5 seconds, insert second key: turn and hold in IGN "ON" position. After approx. 10 seconds, the door chime

will sound** once to indicate vehicle is in programming mode.

YOU NOW HAVE 60 SECONDS TO PROCEED WITH THE NEXT STEP.

3- For the next 2 steps position & hold the PKU module (screw side) towards the front of the ignition barrel (key cylinder).

(Coil Loop is NOT USED during PK programming)

4- Using a jumper wire, power up vehicle ignition, without starting vehicle, for approx. 10 secs. until the "THEFT" light

comes "ON" solid. "THEFT" light will then flash and return back to solid to indicate the PKU module is now

programmed successfully.

IMPORTANT NOTE:

Once the PK (Transponder Bypass) portion has been programmed to a vehicle, it cannot be used on any other

Chrysler vehicle. (This a Chrysler Sentry Key feature from factory.)

TECH NOTE:

- No wiring harnesses should be connected while programming Transponder Bypass.

- Do not install bypass module on a metal surface.

- Do not install resistor's they are internal.

Brown (-)

Ground when running (remote start installations only)

Green

N/C

Blue

N/C

Violet/White

DATA OUTPUT TO VIOLET/BROWN (2ND START WIRE)

+12 VOLT STARTER INPUT TO REMOTE STARTER

Violet (+)

Pink/White (-)

DISARM INPUT

IGNITION INPUT

Pink (+)

Orange

N/C

(+) 12 VOLT CONSTANT

Red

Black

CHASSIS GROUND

Generation

Connector

WIRE FUNCTIONS

PKU MODULE PROGRAMMING MODE

Bypass Method: RF override through induction using loop antenna.

COIL

**As a reference: door should be left open during programming.

No Key Required)

NOTE:

LOCATE THE COIL AROUND THE IGNITION KEY

3 OR 5 TURNS OF LOOP IS REQUIRED

YOU CAN PROGRAM THE TRANSPONDER ONLY ONCE.

Installation

Manual (1\3 Pages)

which initiates the 2nd