Clark Synthesis Prosound429 Installatiehandleiding - Pagina 8
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Clark Synthesis Prosound429. Clark Synthesis Prosound429 9 pagina's.
Pagina afdrukken
TROUBLESHOOTING
The Prosound429 stopped working:
•
If the Prosound429 stops playing, it is likely that the built-in protection circuit has activated. In the event
this happens, turn the amplifier off for approximately 60 seconds to allow the circuit to reset. Turn down
the volume on the audio system and amplifier. Operate the system at lower volume levels to avoid
overloading the Prosound429.
•
If the Prosound429 still does not play, check to insure all wiring connections are properly connected and
that output is coming from the audio system.
The lights in my TC-101 Amp Interface are flashing very brightly:
•
This indicates the input audio signal going to the Prosound429 is too high.
•
Turn the gain/volume down on the audio equipment and the amplifier until the lights are not flashing as
brightly (no flash to a slight flash is acceptable).
The Prosound429 is buzzing:
•
Ensure the Prosound429 is not touching another object (e.g., drum stand, equipment rack, etc.)
•
Check the tightness of the jam nuts and threaded stud to insure they are secure.
•
This may indicate the input audio signal going to the Prosound429 is too high, turn the gain/volume down
on the audio equipment and the amplifier until the buzzing stops.
There is not enough output (feel) in the throne:
•
Move the Prosound429 directly under where you sit on the drum throne.
•
Move the Prosound429 directly under where you stand on the platform.
•
Insure the drum throne you are using is not overly thick or padded
•
Consider adding a second Prosound429 to your throne or platform
8
Prosound429
For additional questions/concerns/issues, contact
Clark Synthesis or check our web site at
www.clarksynthesis.com.
© 2015 Clark Synthesis, Inc.
All Rights Reserved.
Clark Synthesis, Inc.
303.797.7500
Fax: 303.797.7501
www.clarksynthesis.com