Clark Synthesis TST429 Installatiehandleiding - Pagina 6

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Clark Synthesis TST429. Clark Synthesis TST429 20 pagina's. Platinum, gold, silver and all weather transducers
Ook voor Clark Synthesis TST429: Aanvullende handleiding (4 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (1 pagina's), Kopershandleiding (2 pagina's), Installatiehandleiding (20 pagina's), Specificatie (1 pagina's)

Pagina afdrukken
Clark Synthesis TST429 Installatiehandleiding

Installation: Overview

Installation Type: Unimount Bracket
Screws into the bottom of the mounting surface.
Requires access only to the bottom of the mounting
surface. Requires a flat or nearly flat mounting
surface.
Minimum 4-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Unimount
Bracket
Flat Washer
Lock Washer
Screw
Jam Nut (up)
Transducer Lead Wire
Tactile Sound Transducers
6
NEVER TIGHTEN
BY TURNING THE
Transducer. MAKE
SURE TO TIGHTEN
THE JAM NUT
AGAINST THE
Transducer'S BRASS
NUT
3/8"-16
Threaded Stud
Jam Nut (down)
Washers
Screw
Jam Nuts
Installation Type: Hanger Bolt
Screws into the bottom of the mounting surface
(into a 5/16" drilled hole). Requires access only to
the bottom of the mounting surface.
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Minimum
3/4"-thick
Transducer Lead Wire
Tip: Tighten
two jam nuts
against each
other to screw in
hanger bolt using
wrench.
Joist
(edge view)
Drill 5/16" hole
3/8"-16
Hanger Bolt
Jam Nut (down)
Jam Nut
www.clarksynthesis.com