Directed Xpresskit DBALL2 Handleiding voor installatie en snelle referentie - Pagina 13

Blader online of download pdf Handleiding voor installatie en snelle referentie voor {categorie_naam} Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 16 pagina's. Ford5 remote start ready (rsr) installation
Ook voor Directed Xpresskit DBALL2: Installatiehandleiding (12 pagina's), Installatiehandleiding (19 pagina's), Installatiehandleiding (18 pagina's), Handmatig (14 pagina's), Installatiehandleiding (13 pagina's), Installatiehandleiding (14 pagina's), Installatiehandleiding (19 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (20 pagina's), Installatiehandleiding (15 pagina's), Installatiehandleiding (18 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (18 pagina's), Installatiehandleiding (16 pagina's), Handmatig (19 pagina's), Installatiehandleiding (11 pagina's), Installatiehandleiding (10 pagina's)

Platform: DBALL2

Firmware: GM6

Feature Programming

To enter feature programming routine

Turn the ignition ON, then OFF.

Within 5 seconds, press and HOLD the programming button until the LED turns ON orange (after 3 seconds). Release the

Programming button.

The LED will flash green once slowly to indicate the feature number is 1. After a short delay, the LED flashes red rapidly to indicate

the current option of feature 1 (i.e. 1x green followed by 1x red indicates feature 1 is set to option 1). The flashing sequence will

repeat until a new command is entered.

Changing feature options

Press the lock/arm or unlock/disarm button on aftermarket transmitter to change the option of the selected feature.

The LED flashes red rapidly the number of times equal to the current option number. After a short delay, the LED flashes green

slowly the number of times to indicate the current feature. The flashing sequence will repeat until a new command is entered.

Accessing another feature

Press and release the programming button a number of times to advance from the current feature to the next desired feature.

The LED flashes green slowly the number of times equal to the feature number. After a short delay, the LED flashes red rapidly to

indicate the current option of the current feature. The flashing sequence will repeat until a new command is entered.

When the maximum number of features or options is reached, the LED will start flashing again from the first feature or

option.

Once a feature is programmed

Other features can be programmed.

The feature programming can be exited.

Exiting feature programming

No activity for 30 seconds; after 30 seconds, the LED will turn ON orange for 2 seconds to confirm the end of the programming

sequence.

Press and HOLD the programming button for 3 seconds. After 3 seconds, the LED will turn ON orange for 2 seconds to confirm

the end of the programming sequence.

Rev.: 20151221

Page 13

Programming

Button