Directed Xpresskit DBALL2 Installatiehandleiding - Pagina 14

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 16 pagina's. Ford5 remote start ready (rsr) installation
Ook voor Directed Xpresskit DBALL2: Installatiehandleiding (12 pagina's), Installatiehandleiding (19 pagina's), Installatiehandleiding (18 pagina's), Handmatig (14 pagina's), Installatiehandleiding (13 pagina's), Installatiehandleiding (14 pagina's), Installatiehandleiding (19 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (20 pagina's), Installatiehandleiding (15 pagina's), Handleiding voor installatie en snelle referentie (16 pagina's), Installatiehandleiding (18 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (18 pagina's), Handmatig (19 pagina's), Installatiehandleiding (11 pagina's), Installatiehandleiding (10 pagina's)

Pagina afdrukken

Directed Xpresskit DBALL2 Installatiehandleiding

Platform: DBALL2

Firmware:

CHRYSLER4

LED

Description

External module synchronization

OBDII feature is not supported.

(Flashes red,

red then

orange) x 10

Activation Ground When Running (Status)

Flashes

Ground When Running (Status) command received.

green

Ignition ON command received.

Flashes red

& orange

Flashes

Start ON command received.

green

quickly

Flashes red

PTS shutdown error.

x 10

Flashes red

CAN bus incorrectly detected.

x 21

Commands

Flashes

LOCK command received.

orange x 1

Flashes

UNLOCK command received.

orange x 2

Flashes

TRUNK command received.

orange x 3

Flashes

AUX1 command received.

orange x 4

Flashes

AUX2 command received.

orange x 5

Flashes

AUX3 command received.

orange x 6

Shutdown codes

Flashes

Takeover successful.

green x 1

Flashes red

Runsafe was not disabled.

x 1

Flashes red

Brake was not detected.

x 2

Flashes red

Smart key was not detected.

x 3

Flashes red

Speed was detected.

x 4

Troubleshooting

The diagnostic data bus was not detected, therefore the

SmartStart features will be limited.

The module has initialized the remote start sequence.

The module has received the Ignition ON command and

is processing the remote start sequence.

The module has received the Start ON command and is

processing the remote start sequence.

The PTS output from the module was not activated due

to safety protection.

Verify the CAN1 and CAN2 connections. Refer to

"Installation (wiring diagrams & vehicle wiring reference

charts)" to check the connections.

If the bypass module fails to flash, it did not receive the

signal. Commands can come from RF or D2D.

Normal operation.

No UNLOCK command was received prior to opening the

door, or the 45 second timer expired in takeover mode.

The brakes were not detected, which prevents the

system from shutting down the vehicle.

The smart key was not detected, which prevents the

system from shutting down the vehicle.

The vehicle was detected as moving, which prevents the

system from shutting it down.

Rev.: 20170818

Page 14