Clarke 3110380 Gebruiks- en onderhoudsinstructies - Pagina 5

Blader online of download pdf Gebruiks- en onderhoudsinstructies voor {categorie_naam} Clarke 3110380. Clarke 3110380 11 pagina's. Air stapler

AIR SUPPLY

Compressed air can be dangerous. Ensure that you are thoroughly familiar with

all precautions relating to the use of compressors and compressed air supply.

Tools of this type, operate on a wide range of air pressures. It is recommended that air

pressure be set to between 60 and 100psi. at the tool when running.

Higher pressure and unclean air will shorten the tools' life because of faster wear, and could

be a safety hazard.

Water in the air line will cause damage to the tool, ensure it is properly maintained at all times.

The recommended procedure to connect this tool to an air supply, is shown on page11.

The air inlet used for connecting air supply, is a 10mm Quick Fit type.

Line pressure, or hose ID., should be increased to compensate for unusually long air hoses

(over 10M). Minimum hose dia. should be 6mm (1/4") ID., and fittings should have the same

inside dimensions.

ASSEMBLY

Ensure the tool is not loaded, then, with the air supply turned OFF, connect the air line to

the Stapler at the Quick Fit coupling.

With your fingers well away from the trigger, and the tool pointed away from you, and

anyone in the vicinity, depress the magazine catch, pull out the magazine and load with

appropriate staples...as shown. Push the magazine back until it locks in position, - Your stapler

is now ready for use.

Turn ON the air supply, and check for air leaks. If any are apparent, rectify before

proceeding. Ensure the operating pressure is set to between 4-7bar (60-100psi), depending

upon the size of staple used and type of material being worked. The harder the material,

and bigger the staple, the higher the pressure.

Hold the tool so that it is at right angles to the work. Lower it so that the Safety Element

contacts the work surface, and is forced upwards. This movement releases the Trigger,

which may now be pulled, driving in the staple.

If the gun jams, ensure the air is turned OFF and the trigger pulled, before opening the

magazine to free the jammed staple.

WARNING!

CSG3K