Clarke 6462182 Gebruiks- en onderhoudsinstructies - Pagina 6

Blader online of download pdf Gebruiks- en onderhoudsinstructies voor {categorie_naam} Clarke 6462182. Clarke 6462182 20 pagina's.

JIGSAW SAFETY INSTRUCTIONS

1. Only use the jigsaw in the manner and for the functions described in these

instructions.

2. Using the correct blade. Use the appropriate saw blade for the material

being cut. Different blades are available from your Clarke dealer.

3. Use of the mains cable. Keep the mains cable well away from the

machine and ensure an adequate electrical supply is close at hand so

that the operation is not restricted by the length of the cable.

4. Working on the bench. Allow sufficient clearance beneath the work to

ensure the blade does not come into contact with the floor, table etc.

5. Switching off. Never place the saw on a table or bench if it has not

completely stopped. The saw blade will continue to reciprocate for a

short time after the trigger has been released to stop the saw.

6. Cutting of pipes. Do not cut hollow pipe and do not cut material above

the specified thickness.

7. Cutting into walls. Do not cut through walls or cavities before checking for

hidden electrical wires or water pipes etc.

8. Finishing cutting. Do not remove tool from work until the blade has

completely stopped. Do not touch the blade immediately after use, allow

time for it to cool.

9. Use outdoor extension leads. If working outdoors, always use an approved

cable extension suitable for the power rating of this tool (see

specifications), the conductor size should also be at least the same size as

that on the machine, or larger. When using a cable reel, always unwind

the cable completely. We strongly recommend that this machine is

connected to the mains supply via a Residual Current Device (RCD).

10. Cutting sheet materials. Do not cut work less than at least twice the pitch

of the saw blade. i.e. at least two teeth must be in contact with the work

at all times.

11. Always hold the saw by its insulated handle. The saws metal parts may

become conductive if the blade should come into contact with the

mains cable.

12. Beware of foreign objects. When cutting pre-used wood, ensure all nails

have been removed beforehand. Nails will damage the wood saw blade.

13. Cooling agents. When cutting metals, always use a cooling agent i.e.

cutting/soluble oil.

14. Changing the blade. Be careful during adjustment of the machine to

prevent entrapment of the fingers between a moving blade and fixed

parts of the machine. Ensure the blade is fully tightened before use.

Please keep these instructions in a safe place for future reference.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]