Clarke CAG120 Gebruiks- en onderhoudsinstructies - Pagina 6
Blader online of download pdf Gebruiks- en onderhoudsinstructies voor {categorie_naam} Clarke CAG120. Clarke CAG120 6 pagina's. 4½” (115mm) angle grinder
Pagina afdrukken
Electrical Connections
Double Insulated Electrical Appliance
This appliance is of Double Insulation Construction. Because of this, there is no Earth conductor
in the mains supply cable.
Connect the mains lead to a standard 230V (50Hz) electrical supply through an approved
13 Amp BS1363 plug, or a suitably fused isolator switch.
The two wires in the mains lead should be wired up in accordance with the following colour
code:
IMPORTANT : The wires in the mains lead are coloured in accordance with the following
!
code:
Blue
Brown
As the colours of the flexible cord of this appliance may not correspond with the coloured
markings identifying terminals in your plug proceed as follows:
Connect BROWN coloured cord to plug terminal marked with a letter L or coloured RED
Connect BLUE coloured cord to plug terminal marked with a letter N or coloured Black
!
IMPORTANT: If this appliance is fitted with a plug which is moulded on to the electric
cable (i.e. non- re-wireable) please note:
1. The plug must be thrown away if it is cut from the electric cable. There is a danger of
electric shock if it is subsequently inserted into a socket outlet.
2. Never use the plug without the fuse cover fitted.
3. Should you wish to replace a detachable fuse carrier, ensure that the correct replacement
is used (as indicated by marking or colour code).
4. Replacement fuse covers can be obtained from your local dealer or most electrical
stockists.
5. The fuse in the plug must be replaced with one of the same rating (13 amps) and this
replacement must be ASTA approved to BS1362.
!
IMPORTANT: If in any doubt, do not attempt any electrical repair yourself. Consult a
qualified technician
-
Neutral
-
Live
5
Figure (1) Overview
1
2
5
1
Safety ON/OFF Switch
2
Spindle Lock Button
3
Adjustable Guard
Before Using the Grinder
Fit the Handle : Screw the handle
(4)
head as required.
Mount the Grinding Wheel / Cutting Disc : See page 7
Adjust the Guard : The guard
(3)
needs to be adjusted to give maximum protection
from sparks and debris produced when grinding. Slacken the Hex Socket head screw
securing the guard and rotate into position, then retighten the screw.
Connectting to the Power Supply : Connect to the power supply using a Residual Current
Device. Do not use in wet or damp conditions.
!
WARNING ! Ensure that the power supply is disconnected before adjusting the guard or
mounting the handle.
3
4
4
Handle
5
Abrasive Disk
6
Carbon Brush Caps
into the left or right hand position in the grinder
( i )
for details
6
6