Clarke CPSB100B Handleiding voor bediening en onderhoud - Pagina 8

Blader online of download pdf Handleiding voor bediening en onderhoud voor {categorie_naam} Clarke CPSB100B. Clarke CPSB100B 17 pagina's.

ABRASIVE SELECTION AND LOADING

The type of abrasive you choose will greatly influence the amount of time

needed to clean a given surface area. See page 12 for suitable abrasives.

• To prevent clogging, ensure that the abrasive you use is dry.

• While you may re-use abrasive but remember that abrasive grit/

material does wear out. With use, abrasive becomes smoother and

rounder, thus reducing its effectiveness.

NOTE: Re-using abrasive may also cause clogging due to fine debris

contained in the medium from prior use.

4. Close the air supply valve by

turning it to the closed position,

see Fig 8.

5. Squeeze the trigger to release any

pressure from the tank.

• Make sure the pressure gauge

reads "0".

6. Remove the filler cap.

7. Using the sieve and funnel

supplied, pour the abrasive

material into the tank, see Fig 9.

• Do not fill the tank more than ¾

full.

• If humidity in your region is 90%

or more, only fill the tank ½ full

and check the water trap more

frequently.

8. Replace the filler cap ensuring the

O-ring is in place.

NOTE: Position your air compressor

in another room to prevent damage from the intake of abrasive

dust laden air.

• Choose a larger nozzle for a broader spray pattern. Choose a

smaller nozzle for more focused spray.

• Adjust air pressure with the throttle valve. Adjust abrasive flow with

the abrasive control valve.

• Watch for abrasive clogging. Release pressure from the tank if

necessary and replace the abrasive with drier or cleaner abrasive.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Fig 8

Fig 9