Clarke CSA10F Handleiding voor gebruik en onderhoud - Pagina 4
Blader online of download pdf Handleiding voor gebruik en onderhoud voor {categorie_naam} Clarke CSA10F. Clarke CSA10F 11 pagina's. 10 ton hydraulic press
Pagina afdrukken•
Do not allow anyone to work directly in front of the machine when it is in use.
•
Never tamper with the machine. The safety valve is calibrated and sealed at
the factory, do not attempt to change these settings.
•
Use ONLY the recommended hydraulic oil.
•
Never use the machine for any purpose other than that for which it is
designed.
•
Components of this press are specially designed to withstand the rated
capacity. Do not substitute bolts, pins, or any other components.
•
Always apply the load on the centre of ram plunger. Offset loads can
damage the ram or ram mount and may cause work piece to eject.
•
Before operating, check for signs of cracked welds, bent bed pins, loose or
missing bolts, or any other structural damage. Do not operate if any of these
conditions exist. Have repairs made only by authorised service centres.
•
Remove all loads from press bed before attempting to adjust bed height.
Beware of possible falling bed.
•
Press only on a work piece supported by the press bed.
•
When using accessories such as arbor plates, be certain they are centered
on press bed, and are in full contact with the bed.
•
Parts being pressed may splinter, shatter, or be ejected from the press. Due to
varied applications, it is your responsibility to always use adequate guards,
wear eye protection and heavy protective clothing when operating this press.
•
Keep hands and fingers out of the press and away from the parts that may
pinch and shift.
•
It is the owners responsibility to keep warning decals legible and intact.
Replacement decals may be obtained from Clarke International Spare Parts
Dep't.
•
Failure to heed these warnings may result in damage to the equipment, or
failure resulting in property damage, personal, or even fatal injury.
•
NEVER operate the ram without the bed locating pins fully in place.
•
DO NOT use extension tubes on the pump handle. Excessive effort can cause
severe damage.
4