Calienta 10620599 Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Calienta 10620599. Calienta 10620599 8 pagina's. Oil heater

Pagina afdrukken
Calienta 10620599 Gebruiksaanwijzing
I.
1
2
II.
3
1.
2.
4. 4.
5. 5.
7. 7.
8. 8.
I.
Description
1
Radiator
4
2
Air outlet
3
Stand
5
4
Handle
6
5
Temperature dial
6
Main switch
7
7
Air intake
8
Cable storage
8
II.
Operation
3.
Caution: Remove any packaging before use. Store packaging out of reach of children and use it to
protect the heater during standstill. Check the heater, the power cord, and the power plug for damages.
Do not use the heater if there are any visible signs of damage.
1.
Position the two stands on the bottom side of the heater. Guide the bracket through the gap between the
two outer radiators and hang it into the stand.
2.
Fix both stand with the three supplied wing nuts to the heater.
≥1m
3.
Position the heater on a firm and absolutely level underground observing the spacing shown in fig. 3 on
the left fold-out-page.
4.
Plug the appliance to a suitable 220-240 V~50/60 Hz socket with protective earth.
6.
5.
Set the desired temperature with the temperature dial.
6.
Switch on the heater by turning the main switch to one of the power levels (I = 800 W, II = 1200 W,
III = 2000 W, III 
the radiators without a sound. At power level III 
quick distribution of heat. The switches are lit as long as the heater is operating.
7.
If the room temperature reaches the desired value the heater turns off. If the temperature falls below this
value the heater switches on again automatically.
8.
Turn the main switch to 0 to switch off the heater.
9.
Always unplug the appliance when not in use.
9.
12
Technical data
Nominal voltage
220-240 V~
50/60 Hz
Rated power
2230-2580 W
Protection class
I
Degree of protection
IP X0
Overheat protection
80 °C
 = 2000 W + 400 W,
 = 400 W). At power level I and II the heater supplies heat via
and
the heater uses a built in heat blower for a
III.
Maintenance and care
Caution: Before performing any maintenance and care always unplug the heater and let it cool down.
Cleaning
Wipe the heater with a soft, damp cloth only. Never use scouring powders or chemical cleaning agents.
Never allow the electrical components to become damp.
IV.
Trouble shooting
Problem
Cause
The heater does not heat.
The power supply is off.
Main switch set to 0.
The ambient temperature is
above the temperature set at the
temperature dial.
The overheat protection shut
down the heater.
Strange noise
The heater does not stand
upright.
Solution
Check the fuse. Do not connect the
heater and other appliances to the
same circuit.
Set the main switch to one of the
power levels.
Wait until the ambient temperature
falls below the set value.
Increase target temperature at the
temperature dial until the heater
and the indicator switch on.
Unplug the heater and let it cool
down.
Make sure that neither the air
intake nor the air outlet is blocked.
Position the heater upright on an
even surface.
13