Directed DBALL-GM10 XPRESSKIT Snelle referentiehandleiding - Pagina 14

Blader online of download pdf Snelle referentiehandleiding voor {categorie_naam} Directed DBALL-GM10 XPRESSKIT. Directed DBALL-GM10 XPRESSKIT 16 pagina's.

Pagina afdrukken

Platform: DBALL

Firmware: GM10 v. 2.08+

LED Diagnostics and Troubleshooting

LED

Status

Module Programming

Solid Red

Solid

Flashes Orange

Flashes

Flashes Green

Flashes

Solid

Solid Green 3 seconds

x3 sec.

Flashes Red 1 time

Flashes x1

Flashes Red 2 times

Flashes x2

Flashes Red 3 times

Flashes x3

Flashes Red 4 times

Flashes x4

Flashes x5

Flashes Red 5 times

Flashes Red 6 times

Flashes x6

Flashes Red 7 times

Flashes x7

Active Ground While Running

Flashes Green

Flashes

Off

Inactive Ground While Running

Flashes x1

Flashes Green once

Flashes x2

Flashes Green twice

Flashes Green 3 times

Flashes x3

Description

Waiting for Can detection.

CAN and Data Bypass

successfully detected.

Cycle timeout started.

Module successfully

programmed.

Data Bypass line sleeping or not

connected.

Failed to completely remove the

key from ignition or turned the

ignition OFF without removing the

key while bypass sequence was

executing.

Cycle (programming steps 5 to 7)

timed out.

Data Bypass line sleeping or not

connected.

Programming failed.

HS CAN not detected.

SW CAN not detected.

Ground out (GWR) is active.

Normal operation

Lock function executed.

Unlock function executed.

Trunk release function executed.

Troubleshooting

Make sure that your HSCAN and SWCAN are properly

connected and press Unlock on the OEM remote.

Normal operation

Normal operation. You have now 5 seconds to finish module

programming.

Normal operation

Press Unlock on the OEM remote to activate the Data Bypass.

Cycle (programming steps 5 to 7) was done without removing

the key. Reset module and retry module programming from

step 1.

Cycle (programming steps 5 to 7) was done slower than 5

seconds. Reset module and retry module programming from

step 1.

Make sure that your connections to Data Bypass are correct,

remove key, press Unlock on the OEM remote and make sure

that the LED is flashing orange before turning the key to

ignition.

Reset the module and retry the module programming from step

Check connections and click Unlock again to activate the line.

Normal operation

The Ground While Running (status) wire is incorrectly

connected. Refer to the wiring diagram to make the right

connections.

If it does not flash, the bypass module did not receive the signal.

Verify the connections between the bypass and the remote

starter module.

Rev.: 20130304

Page 14