Zanussi ZC 260 R3 Instructieboekje - Pagina 10

Blader online of download pdf Instructieboekje voor {categorie_naam} Zanussi ZC 260 R3. Zanussi ZC 260 R3 12 pagina's. Fridge zc 260 r3

Pagina afdrukken

•

During normal operation, the condenser and

compressor at the back of the appliance heat up

considerably. For safety reasons, minimum

ventilation must be as shown in the instructions.

•

Care must be taken to ensure that the appliance

does not stand on the electrical supply cable.

if the supply cord is damaged, it must

be replaced by a special cord or assembly availa-

ble from the manufacturer or its service agent.

•

If the appliance is transported horizontally, it is

possible that the oil contained in the compressor

flows in the refrigerant circuit. It is advisable to

wait at least two hours before connecting the

appliance to allow the oil to flow back in the

compressor.

•

There are working parts in this product which

heat up. Always ensure that there is adequate

ventilation as a failure to do this will result in

component failure and possible food loss. See

installation instructions.

•

Parts which heat up should not be exposed.

Wherever possible the back of the product should

be against a wall.

Cleaning the interior

Operation

Temperature regulation

Fresh food refrigeration

Movable shelves

Positioning the door shelves

Hints for refrigeration

Periodic cleaning

Periods of no operation

Interior light

Defrosting

Location

Electrical connection

Rear spacers

Changing the opening direction of the door

The plastic bag containing all relevant

documentation also contains two rear wall spacers

to be fitted into special slots on the back of the

appliance. Fit the spacers into the slots, taking care

to ensure that the arrow (A) is positioned as shown

in the figure. Next, turn them through 45° (arrow in

vertical position) until they lock into place.

Before buiding-in the appliance (if necessary),

change the opening direction of the door. To do this,

proceed as follows:

1. Remove the lower hinge (1) and feet (3)

2. Slide the door out from pin (G) and place it on the

opposite side;

3. Unscrew the foot front left and place it on the

opposite side;

4. Unscrew the two screws which mask the holes

for fixing the hinge on the front left side;

5. Reassemble the door

6. refit the lower hinge and feet (3) on the opposite

side;

7. dismantle the handle and reassemble it on the

opposite side.Cover the holes left open with the

plugs contained in the documentation pack.

45°

PR60

D715 PIED/C

D162/1