Clarke Woodworker CPT600 Gebruiks- en onderhoudsinstructies - Pagina 7
Blader online of download pdf Gebruiks- en onderhoudsinstructies voor {categorie_naam} Clarke Woodworker CPT600. Clarke Woodworker CPT600 18 pagina's. Planer/thicknesser
Ook voor Clarke Woodworker CPT600: Bedienings- en onderhoudshandleiding (18 pagina's)
Pagina afdrukken
All manuals and user guides at all-guides.com
UNPACKING and PARTS IDENTIFICATION
Carefully unpack the components and lay them out, checking against the
following list. Should any part be missing or damaged in transit, please contact
your Clarke dealer immediately.
NOTE:
Dust extraction
devices
are
available
from
your Clarke dealer
ASSEMBLY and INSTALLATION
Ensure the planer is located where there is adequate light, and a suitable power
supply. If cable a extension is used, ensure it does not trail along the workshop
floor as this could be extremely hazarous.
There must be sufficient room for the workpiece to move through its entire length.
Similarly, there must be sufficient room so that the operator does NOT need to
stand in line with the wood during the planing process.
The planer may be used as a mobile unit, but for greater stability we recommend
it is bolted to a strong, firm workbench. The dimensions for the mounting holes are
shown below:
Alternatively, mount the planer on a
strong piece of plywood of at least
15mm in thickness, with length
550mm and width 380mm minimum.
The plywood platform, with planer
mounted, is then clamped firmly to a
workbench when required.
Fig. 2
7
Fig. 1