Zanussi ZQA14030DA Gebruikershandleiding - Pagina 7
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZQA14030DA. Zanussi ZQA14030DA 12 pagina's. Refrigerator
Ook voor Zanussi ZQA14030DA: Gebruikershandleiding (36 pagina's), Gebruikershandleiding (45 pagina's), Gebruikershandleiding (49 pagina's), Gebruikershandleiding (36 pagina's)
Pagina afdrukken
Problem
The compressor operates contin-
ually.
Water flows on the rear plate of
the refrigerator.
Water flows into the refrigerator.
Water flows on the ground.
The temperature in the appliance
is too low.
The temperature in the appliance
is too high.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1.
Remove the screw
from the lamp
cover.
2.
Remove the lamp
cover (refer to the
illustration).
3.
Replace the used
lamp with a new
lamp of the same
Possible cause
The lamp is defective.
The temperature is not set correctly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too high.
The room temperature is too high.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
The water outlet is clogged.
Products prevent that water flows into
the water collector.
There is too much water in the air de-
flector.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same
time.
There is no cold air circulation in the
appliance.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than
necessary.
Let the product temperature decrease to
room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Clean the air deflector.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease to
room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
power and specifically designed for household ap-
pliances (the maximum power is shown on the lamp
cover).
4.
Install the lamp cover.
5.
Tighten the screw to the lamp cover.
6.
Connect the plug to the mains socket.
7.
Open the door. Make sure that the light comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
Solution
7