Zanussi ZRB224NXO Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZRB224NXO. Zanussi ZRB224NXO 14 pagina's.

Pagina afdrukken

Location

The appliance should be installed well away

from sources of heat such as radiators , boilers ,

direct sunlight etc. Ensure that air can circul-

ate freely around the back of the cabinet. To

ensure best performance , if the appliance is

positioned below an overhanging wall unit , the

minimum distance between the top of the cabi-

net and the wall unit must be at least 100 mm.

Ideally , however , the appliance should not be

positioned below overhanging wall units. Accu-

rate leveling is ensured by one or more adjust-

able feet at the base of the cabinet.

Warning It must be possible to disconnect

the appliance from the mains power suppl-

y; the plug must therefore be easily acce-

ssible after installation.

Electrical connection

Any electrical work required to

Caution

install this appliance should be carried

out by a qualified electrician or competent

person.

Warning This appliance must be earthed.

The manufacture declines any liability

should these safety measures not be

observed.

Important

The wires in the mains lead are

colored in accordance with the following code:

Green and Yellow

Brown

Blue

As the colours of the wires in the mains lead

of this appliance may not correspond with the

coloured markings identifying the terminals in

your plug , proceed as follows:

1. Connect the wire coloured green and yellow

to the terminal marked either with the letter

"E" or by the earth symbol

Earth

Live

Neutral

or coloured

green and yellow.

2. Connect the wire coloured blue to the termi-

nal either marked with the letter "N" or col-

oured black.

3. Connect the wire coloured brown to the ter-

minal either marked with the "L" or colour-

ed red.

4. Check that no cut , or stray strands of wire is

present and the cord clamp

over the outer sheath.

5. Make sure the electricity supply voltage is

the same as that indicated on the appliance

rating plate.

6. Switch on the appliance.

The appliance is supplied with a 13 amp plug

fitted

. In the event of having to change the

fuse in the plug supplied , a 13 amp ASTA

approved (BS 1362) fuse must be used.

Warning A cut off plug inserted into a 13

amp socket is a serious safety (shock) ha-

zard. Ensure that it is disposed of safety.

Levelling

The appliance should be level in order to elim-

inate vibration. To make the appliance level , it

should be upright and both adjusters should be

firmly contacted with the floor. You can also

adjust the level by screwing out the appropriate

level adjuster at the front (use your fingers or

a suitable spanner).

Door reversibility

The side at which the door opens can be

right side (as supplied) to

changed from the

the left side , if the installation site requires.

Before you start lay the refrigerator on its back

in order to gain access to the base , you should

rest it on soft foam or similar material to avoid

damaging the cooling pi pes at the rear of refri-

gerator.

1. Stand the refrigerator , use a flat bladed

screw driver to remove the 4 screw covers

in the refrigerator lid.

is secure