Zanussi ZRB324WO1 Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZRB324WO1. Zanussi ZRB324WO1 30 pagina's.
Pagina afdrukken
Remaining small ice and frost stains on back plate of
the refrigerator after defrosting period is not abnormal.
The freezer can not be equipped with automatic
defrosting set since the deep-frozen and frozen foods do
not endure melting temperature.
When small frost and ice occurs scrape off and remove
frost and ice coating with the supplied plastic scraper.
The tray in figure is not a piece of accessories to the
appliance!
When ice coating is so thick that it cannot be removed
with the plastic scraper, the cooling plate has to be
defrosted. Frequency of defrosting depends on usage
(generally 2-3 times a year).
Take the frozen foods out of the appliance, and put
them into a basket lined with paper or cloth. Store them
in a possibly cool place or replace them into another
refrigerator.
Pull out the mains plug from the mains socket, so both
parts of the appliance are out of operation.
Open the doors of both parts of the appliance and clean
the refrigerator according to Regular cleaning. Maintain
and clean the freezer as following:
Sweep the melting water with a cloth or sponge off the
cooling plate. The melting water swept down gathers in
the bottom of the appliance and can be removed with a
hygroscopic cloth or a sponge.
Wipe the surfaces after defrosting.
Put the mains plug into the mains socket and put foods
taken out back to their places.
It is recommended to operate the appliance at the
highest position of the thermostatic control for some
hours so that it can reach the sufficient storing
temperature as soon as possible.
Regular cleaning
It is recommended to wash the inside of the refrigerator
in 3-4 weeks time using lukewarm water then wipe it (it
is practical to clean the inside of the freezer and defrost
it at a time).
Household cleaner or soap must not be used.
8
GB
After breaking the circuit wash the appliance with
lukewarm water then wipe it. Clean the door gasket
with clean water. After cleaning apply voltage to the
appliance.
It is recommended to remove the dust and dirt collected
on the back of the refrigerator and the condenser and
to clean the evaporative tray on top of the compressor
once or twice a year.
When the refrigerator is not in use
In case the appliance will not be used for a long time,
follow these steps: Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
Trouble shooting
How to change the bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Press the front hook and at the same time slide the
cover in the direction indicated by horizontal arrow
(1), than remove cover by pulling it gently down as
indicated by arrow (2). So the bulb can be replaced.
(Bulb type: 230-240 V, 15 W, F 14 thread) After
changing the bulb replace the cover, snap it in place and
apply voltage to the appliance.