Zanussi ZRB33104XA Gebruikershandleiding - Pagina 10
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZRB33104XA. Zanussi ZRB33104XA 16 pagina's.
Ook voor Zanussi ZRB33104XA: Gebruikershandleiding (44 pagina's)
Pagina afdrukken
Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
There is too much frost
and ice.
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
The temperature in the re-
frigeration is too high.
The temperature in the
freezer is too high.
The appliance does not
operate.
The lamp does not work.
10
Possible cause
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
Products are not wrapped properly.
The door is not closed correctly.
The Temperature regulator may be
set incorrectly.
The Temperature regulator may be
set incorrectly.
The Temperature regulator may be
set incorrectly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each oth-
er.
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
Solution
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Wrap the products better.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same
time.
Make sure that there is cold air circu-
lation in the appliance.
Store products so that there is cold
air circulation.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
www.zanussi.com