Zanussi ZRB834NW Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZRB834NW. Zanussi ZRB834NW 16 pagina's.

Pagina afdrukken
Problem
Water flows on the ground.
There is too much frost and
ice.
The temperature in the appli-
ance is too low.
The temperature in the appli-
ance is too high.
The temperature in the refrig-
eration is too high.
The temperature in the freez-
er is too high.
The appliance does not oper-
ate.
The lamp does not work.
As much as the advice does not lead to result, call the nearest brand-mark service.

Replacing the lamp

Caution! Disconnect the plug from the mains
socket.
1. Remove the screw from the lamp cover.
2. Pull outwards the hook of the lamp cover.
10
Possible cause
Products prevent that water flows in-
to the water collector.
The melting water outlet does not
flow in the evaporative tray above the
compressor.
Products are not wrapped properly.
The door is not closed correctly.
The Temperature regulator may be
set incorrectly.
The Temperature regulator may be
set incorrectly.
The Temperature regulator may be
set incorrectly.
The door is not closed correctly.
The product temperature is too high. Let the product temperature decrease
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
Products are too near to each other. Store products so that there is cold air
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is defective.
Make sure that products do not touch
the rear plate.
Attach the melting water outlet to the
evaporative tray.
Wrap the products better.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circu-
lation in the appliance.
circulation.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
Refer to "Replacing the lamp".
3. Remove the lamp cover.
4. Replace the lamp with one of the same power (the
maximum power is shown on the light bulb cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the plug to the mains socket.
Solution