Zanussi ZRB939NW2 Gebruikershandleiding - Pagina 12
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZRB939NW2. Zanussi ZRB939NW2 16 pagina's.
Pagina afdrukken
Problem
The lamp does not work.
As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
1.
Disconnect the appliance.
2.
Push the movable part to unhook the lamp cover (1).
3.
Remove the lamp cover (2).
4.
If needed replace the lamp with a light of similar
characteristic and power. It is suggested to use Os-
ram PARATHOM SPECIAL T26 0.8 Watts.
5.
Install the lamp cover.
6.
Connect the appliance.
7.
Open the door. Make sure that the lamp comes on.
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.
Installation
Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
12
Possible cause
The lamp is in stand-by.
The lamp is defective.
Height
Width
Depth
Close and open the door.
Refer to "Replacing the lamp".
1
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
3.
If necessary, replace the defective door gaskets.
Contact the Service Center.
2010 mm
595 mm
658 mm
18 h
230-240 V
50 Hz
Solution
2
www.zanussi.com