Clarke X-PRO CAT140 Gebruiks- en onderhoudsinstructies - Pagina 8
Blader online of download pdf Gebruiks- en onderhoudsinstructies voor {categorie_naam} Clarke X-PRO CAT140. Clarke X-PRO CAT140 17 pagina's. Air shear
Pagina afdrukken
OPERATION
USING THE SHEAR
1. Place the shear against the side
of the sheet metal you want to
cut, see below.
2. Squeeze the trigger to start the
metal shear.
3. Maintain constant pressure to
move the tool through the sheet
metal.
4. Release the trigger to stop the
metal shear.
5. Always ensure the tool has stopped before putting it down.
WORKING AT AN ANGLE
The shears can be set to operate in
line with the handle or at an angle,
for example, if working in a confined
space.
1. To do this, re-set the nose section
in its new position by slackening
the hex screw shown using the
key, and rotating the nose
assembly to the angle required.
• It can be set at any angle
required.
2. Ensure you have re-tightened the screw before using the shear.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air supply hose until the compressor has been shut
down and the compressed air released.
2. Refer to the compressor instruction manual for the procedure to shut down
and vent the compressed air.
3. Once the pressure has been released, disconnect the air supply hose from
the air tool.
4. Store the tool safely in its box in a dry, secure environment.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8