Zanussi ZX 56/4 W Instructieboekje - Pagina 4

Blader online of download pdf Instructieboekje voor {categorie_naam} Zanussi ZX 56/4 W. Zanussi ZX 56/4 W 10 pagina's. Zanussi instruction booklet refrigerator- freezer zx 56/4 w, zx 56/4 sa, zx 56/4 si
Ook voor Zanussi ZX 56/4 W: Instructieboekje (24 pagina's), Instructieboekje (12 pagina's)

Pagina afdrukken

Remove all securing tapes. Wash inside the

appliance with lukewarm water and bicarbonate of

soda (5 ml to 0.5 litre of water).

A - Thermostat control knob

B - Pilot light

Allow the appliance to stand for 2 hours after

installation.

Plug in the appliance and switch on at the mains

supply. Turn the thermostat control (A) to a midway

setting (3-4) and adjust the slider control, situated on

the back wall of the fridge section, to a midway

position between "MIN" and "MAX". The pilot light (B)

will light up. Leave the appliance for approximately 4

hours for the correct temperature to be reached

before placing food inside.

To switch off the appliance turn the thermostat

control to position "

The temperature inside the appliance is regulated by

a thermostat with 6 temperature positions and an

"OFF" (O) position.

Position 1 = minimum coldness

Position 6 = maximum coldness

Turn the thermostat control knob to the required

position.

The thermostat control knob regulates the

temperature both within the fridge and the freezer

compartment. The thermostat setting can vary as the

temperature inside the appliance depends on the

following factors:

– room temperature

– how often the door is opened

– how much food is stored

– position of the appliance

1. Disconnect from the electricity supply.

2. Remove all loose items, including food, store food

in a cool place.

3. Gently lay the fridge/freezer on its back with the

top held away from the floor by 5-8 cm (2-3

inches) of packing.

4. Remove the feet (B).

5. Remove bottom hinge (A).

6. Remove the freezer door by releasing it from the

middle hinge (H).

7. Unscrew the middle hinge.

8. Slide out the fridge door from pin (G), unscrew pin

(G) and then screw it down into the hinge hole

provided on the opposite side, after having

removed the small plugs which should then be

fitted on the opposite side.

9. Remove the plastic blanking screws from the left

hand hinge position, refit to the right hand hinge

position.

10.Refit the fridge door and replace the middle hinge

to the left hand side.

11.Replace the door and bottom hinge (A) on the

opposite side.

12.Refit the feet (B).

After completion of the door reversing operation,

check that the door gasket adheres to the cabinet. If

the ambient temperature is cold (i.e. in Winter), the

gasket may not fit perfectly to the cabinet. In that

case, wait for the natural fitting of the gasket or

accelerate this process by heating up the part

involved with a normal hairdryer on a low setting.

D715

D419