Zanussi 949495307 Gebruikershandleiding - Pagina 25

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi 949495307. Zanussi 949495307 29 pagina's.

Pagina afdrukken

When the oven door is clean, install the glass panel in the opposite sequence. The screen-printing

zone must face the inner side of the door. Make sure that after the installation the surface of the glass

panel frame on the screen-printing zones is not rough when you touch it. Make sure that you put the

glass panel in the rubber distance holders.

HOW TO REPLACE: LAMP

WARNING! Risk of electric shock.

The lamp can be hot.

Step 1

Turn off the oven. Wait until the

oven is cold.

Back lamp

Step 1

Turn the glass cover to remove it.

Step 2

Clean the glass cover.

Step 3

Replace the lamp with a suitable 300 °C heat-resistant lamp.

Step 4

Install the glass cover.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.

WHAT TO DO IF...

Problem

The oven does not heat up.

The lamp does not operate.

Always hold the halogen lamp with a cloth to

prevent grease residue from burning on the lamp.

Before you replace the lamp:

Step 2

Disconnect the oven from the

mains.

Possible cause

The oven is deactivated.

The clock is not set.

The necessary settings are not

set.

The fuse is blown.

The lamp is defective.

Step 3

Put a cloth on the bottom of

the cavity.

Remedy

Activate the oven.

Set the clock.

Make sure that the settings are

correct.

Make sure that the fuse is the

cause of the malfunction. If the

fuse is blown again and again,

contact a qualified electrician.

Replace the lamp.