Zanussi ZOU 361 Gebruikersinformatie - Pagina 23

Blader online of download pdf Gebruikersinformatie voor {categorie_naam} Zanussi ZOU 361. Zanussi ZOU 361 28 pagina's.

Pagina afdrukken

Instructions for the installer

The instructions given below are designed

specifically for a qualified installer and

should aid him or her to perform all

installation, adjustment, and maintenance

operations with absolute precision and in

compliance with all current legislation and

regulations. We strongly recommend that

all operations for the installation of your

cooker be carryed out by Qualified

Personnel in accordance with existing

rules and regulations.

Electrical connection

Prior to making the electrical connection, make sure

that:

— the protection fuse and the domestic wiring system

are suitable to carry the total electric load of the

oven (see rating plate);

— your domestic wiring system has an efficient earth

connection in compliance with rules and laws in

force;

— the wall socket or the omnipole switch used for the

electrical connection can easily be reached after

the oven is built in.

This appliance is delivered without an electric

supply cable, therefore, you will have to fit to it a

supply cable with standard plug, suitable for the

total electric load shown on the rating plate. The

plug is to be inserted into a suitable wall socket. If

you require a direct connection to the electric

network (mains), it will be necessary to fit between

the appliance and the mains an omnipole switch,

with a minimum gap between contacts of 3 mm,

suitable for the required load and in compliance

with rules in force. The green & yellow ground

wire must not be interrupted by the switch, and

should be 2-3 cm longer than the phase and

neutral wires. The supply cable must in all cases

be laid out in such a way as to ensure that it does

not reach at

any given point a temperature 50°C higher than

the ambient temperature.

Suitable power supply cables are the following

types, considering the respective necessary

section of cable: H07 RN-F, H05 RN-F, H05 RR-

F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F.

Connecting the terminal board

The appliance incorporates an easily accessible

6-pole terminal board whose jumpers (bridges)

are already pre-set for operation on 400V

tri-phase with neutral wire. In case a different mains

voltage is present, the jumpers on the terminal

board must be rearranged as shown in the

diagram. The ground cable must be connected to

terminal

. After connecting the supply cable to

the terminal board, secure it with a junction clamp.

FO 0330

230V 3~

230V 1~

400V 2N~

400V 3N~

FO 0584

1 2 3 4 5

L3 PE

1 2 3 4 5

L1 L2

1 2 3 4 5

L1 L2 L3 N