Zanussi FJD 1666 W Instructieboekje - Pagina 23

Blader online of download pdf Instructieboekje voor {categorie_naam} Zanussi FJD 1666 W. Zanussi FJD 1666 W 27 pagina's. Front-load washer
Ook voor Zanussi FJD 1666 W: Instructieboekje (27 pagina's)

Pagina afdrukken

Unpacking

All transit bolts and packing must be removed

before using the appliance.

You are advised to keep all the packaging for re-use in

case the machine is to be transported again.

Using a spanner unscrew and remove the two rear

bottom screws. Slide out the two plastic pins.

Lay the machine gently on its back, making sure that the

hoses are not squashed.

Remove the polystyrene block from the bottom of the

machine and release the two plastic bags.

Very carefully slide out the left polythene bag, removing

it towards the right and then downwards.

Repeat the operation for the right polythene bag,

removing it towards the left and then upwards.

Remove the polystyrene base.

Set the machine upright and unscrew the remaining rear

screw. Slide out the relevant pin.

Fill all the holes with the plastic plugs supplied with the

instruction booklet.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not

impeded by carpets, rugs etc. Check that the machine

does not touch the wall or other kitchen units.

Never place cardboard, wood or similar materials under

the machine to compensate for any unevenness in the

floor.

Your new washing machine has been designed to be

permanently plumbed in to your home's water supply

and drainage system. However, if this is not possible, it

may be connected to a suitable existing tap with the

drain hose discharging into a sink.

The appliance has an inlet hose, with female 3/4" BSP

thread connector. If this connection is not compatible

with the plumbing of the existing installation, a variety

of connectors are available from good hardware stores

and plumbers merchants to suit most domestic

plumbing. Any alteration to your existing plumbing

must be carried out by a competent person, or qualified

plumber.

Installation on a Suspended Floor

Suspended wooden floors are particularly susceptible to

vibration. To help prevent vibration we recommend you

place a waterproof wood panel, at least 15 mm thick

under the appliance, secured to at least 2 floor beams

with screws. If possible install the appliance in one of

the corners of the room, where the floor is more stable.