Zanussi FJS 1025 W Instructieboekje - Pagina 8

Blader online of download pdf Instructieboekje voor {categorie_naam} Zanussi FJS 1025 W. Zanussi FJS 1025 W 29 pagina's. Front-load washer

Pagina afdrukken

Important!

The first time you use the washing machine, when

you switch it on, it may display a blinking zero and give

an audible warning signal. This is due to the fact that the

washing machine has performed a washing cycle during

the manufacturer's inspection tests, and this cycle has

not been erased after its completion.

• Delay start, a time value indicated in hours and

selected by means of the relevant button.

The delay time is displayed for 3 seconds, then the

duration of the selected programme reappears.

After you have pressed the START/PAUSE button, the

countdown begins, and the delay time value decreases

by one unit every hour.

You can delay the start of the selected programme by

up to 24 hours in one hour intervals.

• An incorrect option selection has been made: this is

indicated by the message Err when a function

incompatible with the current programme is selected.

The incorrect selection is also indicated by an audible

warning signal.

• An alarm code indicates a fault in the machine

operation (see the relevant chapter on page 19).

9 START/PAUSE button

This button has three functions:

• Start: after you have selected the desired programme

and options, press this button to start the washing

machine. The light above the button will stop flashing

and remain lit.

If you have selected a delay time by means of button

11, the countdown will begin and will be shown on the

display.

• Pause: when you press this button again, the

programme in progress is interrupted. The light above

the button will start flashing. To restart the programme,

press the button again.

When you PAUSE the cycle, the DOOR LOCKED

light goes out, and it becomes possible to open the

door, provided

• the washing machine is not in the heating phase

beyond 40°C;

• the level of the water is not high;

• the drum is not turning.

Important! You must set the washing machine to

PAUSE before you make any change in the programme

in progress.

• Draining of water and spinning after the execution of

programmes with the RINSE HOLD option.

10 SKIP/RESET button

This button performs two functions:

- Clears the memory

- Selects special programmes

At the end of every programme the RESET button must

be pressed once or repeatedly to clear the programme

memory. This will be confirmed by three dashes,

flashing in the display.

If the previous programme is not cleared, the display

will show a "

" flashing and an audible signal will

sound, when you switch the machine on.

Selecting a special programme:

A wash programme must be selected in the normal way.

(START button not pressed)