Zanussi ZWS 744 Instructieboekje - Pagina 4

Blader online of download pdf Instructieboekje voor {categorie_naam} Zanussi ZWS 744. Zanussi ZWS 744 16 pagina's.

Pagina afdrukken

INSTALLATION

Remove all packaging before positioning the

machine.

Positioning

If possible, position the machine next to a water tap

and a drain.

The sides and the back of the dishwasher can rest

against the adjacent furniture or the wall.

The dishwasher features fill and drain hoses which

can be turned either to the left or the right to suit the

installation.

Levelling

Good levelling is essential for correct closure and

sealing of the door.

If the door does not close correctly, loosen or tighten

the adjustable support feet, until the machine is

perfectly level.

Adjusting the worktop

You can move the worktop forward or backward by 25

mm in order to align the machine with other kitchen

units.

Simply unscrew the two front retaining screws, move

the top to the required position and then retighten the

screws.

IN02

Installing and securing the machine under a

kitchen unit

(sink-worktop unit)

By removing the machine's worktop, you can install it

under a close fitting sink unit or a pre-existing top, if

the dimensions of the recess correspond to those

shown in the picture.

Then proceed as follows:

Remove the machine worktop by unscrewing the two

front retaining screws, pull from the front and slide out

the rear slots, lifting the worktop.

Insert the machine after adjusting the height and level-

ling with the adjustable feet. When inserting the ma-

chine, ensure that the water inlet and drain hoses are

not kinked or squashed.

IN04

Caution

Once the machine has been installed, ensure that it

can be accessed easily for servicing.

Water outlet connection

The end of the drain hose can be connected as

follows:

to the sink outlet siphon, securing it if necessary

with a clip;

to a wall outlet provided with vent-hole, minimum

internal diameter 4 cm;

hooked over the edge of the sink using the special

curved plastic guide provided.

The waste connection must be at a height of between

30 cm (minimum) and 100 cm (maximum) from the

floor.

It makes no difference which way the drain hose

faces, either to the right or left of the dishwasher.

Avoid bending or kinking the hose as this could

prevent or slow down the discharge of water.

If you use a drain hose extension it must be no longer

than 2 metres and its internal diameter must be no

smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used

for connection to the waste outlet must be no smaller

than the diameter of the drain hose.

CS01

PIN13GB

+ 2 m max