Zanussi ZGL640TW Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZGL640TW. Zanussi ZGL640TW 16 pagina's.
Ook voor Zanussi ZGL640TW: Gebruikershandleiding (16 pagina's)

Pagina afdrukken

Provision for ventilation

Detailed recommendations are contained in the

following British Standards Codes Of Practice:

B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891

Current Editions.

The hob should not be installed in a bed sitting

room with a volume of less than 20 m³. If it is

installed in a room of volume less than 5 m³ an

air vent of effective area of 100 cm² is required.

If it is installed in a room of volume between 5

m³ and 10 m³ an air vent of effective area of 50

cm² is required, while if the volume exceeds 11

m³ no air vent is required.

However, if the room has a door which opens

directly to the outside no air vent is required

even if the volume is between 5 m³ and 11 m³.

If there are other fuel burning appliances in the

same room, B.S. 5440 Part 2 Current Edition,

should be consulted to determine the requisite

air vent requirements.

For appliances installed in the Republic of Ire-

land please refer to the NSAI- Domestic Gas

Installation I.S. 813 Current Editions Table

Four.

Location

The hob may be located in a kitchen, a kitchen/

diner or bed sitting room (with a volume greater

than 20 m³), but not in a bathroom or shower

room.

The minimum distance combustible material

can be fitted above the hob in line with the

edges of the hob is 400 mm. If it is fitted below

400 mm a space of 50 mm must be allowed

from the edges of the hob.

For appliances installed in the Republic of Ire-

land please refer to NSAI- Domestic Gas In-

stallation I.S 813 Current Edition Section 7-

Permitted Locations of Appliance.

Gas Connection

Warning! Any gas installation must be

carried out by a GAS SAFE REGISTER

installer.

Make sure that, once the hob is installed, it is

easily accessible for the engineer in the event

of a breakdown.

The manufacturer will not accept liability,

should the above instructions or any of the oth-

er safety instructions incorporated in this in-

struction booklet be ignored.

On the end of the shaft, which includes the G

1/2" threaded elbow, adjustment is fixed so that

the washer is fitted between the components

as shown in the diagram. Screw the parts to-

gether without using excessive force.

B C

A) End of shaft with nut

B) Washer

C) Elbow

Connection to the gas supply should be with

either rigid or semi-rigid pipe, i.e. steel or cop-

per.

The connection should be suitable for connect-

ing to R 1/2 (1/2 BSP male thread).

When the final connection has been made, it is

essential that a thorough leak test is carried out

on the hob and installation.

Make sure that the main connection pipe does

not exert any strain on the hob.

If you use flexible metal pipes make sure that

they agree to ISO 10380 and ISO 10807

standards. Be careful they do not come in

touch with mobile parts or they are not

squeezed. Also be careful when the hob is put

together with an oven.

Important! It is important to install the elbow

correctly, with the shoulder on the end of the

thread, fitted to the hob connecting pipe.

Important! Failure to ensure the correct

assembly will cause leakage of gas.

Important! Make sure that the gas supply

pressure of the appliance obeys the

recommended values.