Zanussi ZIL6470CB Gebruikershandleiding - Pagina 11
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZIL6470CB. Zanussi ZIL6470CB 17 pagina's.
Pagina afdrukken
CARE AND CLEANING
WARNING! Refer to Safety chapters.
GENERAL INFORMATION
•
Clean the hob after each use.
•
Always use cookware with clean bottom.
•
Scratches or dark stains on the surface have no
effect on how the hob operates.
•
Use a special cleaner applicable for the surface
of the hob.
•
Use a special scraper for the glass.
CLEANING THE HOB
•
Remove immediately: melted plastic, plastic
foil, sugar and food with sugar. If not, the dirt
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate or operate
the hob.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
can cause damage to the hob. Take care to
avoid burns. Put the special scraper on the
glass surface at an acute angle and move the
blade on the surface.
•
Remove when the hob is sufficiently cool:
limescale rings, water rings, fat stains, shiny
metallic discoloration. Clean the hob with a
moist cloth and non-abrasive detergent. After
cleaning, wipe the hob dry with a soft cloth.
•
Remove shiny metallic discoloration: use a
solution of water with vinegar and clean the
glass surface with a moist cloth.
Possible cause
The hob is not connected to an
electrical supply or it is con-
nected incorrectly.
The fuse is blown.
You do not set the heat setting
for 10 seconds.
You touched 2 or more sensor
fields at the same time.
Pause operates.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connection
diagram.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Activate the hob again and set
the heat setting in less than 10
seconds.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Remove the object from the
sensor fields.
11