Zanussi ZKT 641 F Handleiding voor installatie en gebruik - Pagina 13
Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} Zanussi ZKT 641 F. Zanussi ZKT 641 F 24 pagina's. Ceramic glass hob
Ook voor Zanussi ZKT 641 F: Handleiding voor installatie en gebruik (28 pagina's)
Pagina afdrukken
What to do if ...
Problem
The cooking zones are not func-
tioning.
The cooking zones cannot be se-
lected / Appliance does not react to
the control panel input
The residual heat indicator is not
displaying anything
Er03
is displayed
Er21
is displayed
Er25
is displayed
(only for 10 seconds)
Er40
is displayed
3
In the event of any other fault codes that arise,
disconnect the appliance from the electrical
supply for a few seconds (Take out the fuse
from the house's wiring system). If the fault
code is displayed again, please call your local
Service Force Centre and report the fault
code.
If you are unable to remedy the problem by fol-
lowing the above suggestions, please contact
your local Service Force Centre.
1
Warning! Repairs to the appliance are only to
be carried out by qualified service engineers.
Considerable danger to the user may result
from improper repairs.
3
If the appliance has been wrongly operated,
the visit from the service technician or dealer
may not take place free of charge, even during
the warranty period.
Possible cause
No cooking zone selected
More than 10 seconds has passed
since the appliance was switched
on
The child safety device is activated
l
The sensor fields are partly covered
by a damp cloth or with liquid
Safety cut-out has been triggered
The cooking zone was only on for a
short time and is therefore not hot
Several sensor fields were touched
at the same time
Safety cut-out due to overheating.
Appliance is incorrectly connected
The overvoltage protector has been
activated (for an incorrect connec-
tion see above Er25 or for over-
heating of the electronic
components see Er21)
Remedy
Select cooking zone within 10 sec-
onds of switching on (Decimal point
lights up)
Switch on the appliance again.
Select cooking zone within 10 sec-
onds of switching on
Deactivate the child safety device
(See section "Child safety device")
Remove the cloth or the liquid
Switch on the appliance again
If the cooking zone is supposed to
be hot, call your local Service Force
Centre.
Only touch one sensor field
Let the appliance cool down.
Remove cookware.
Disconnect the appliance from the
electrical supply and have it con-
nected properly
Separate the appliance from the
mains for a few minutes (remove
the mains fuse).
Let the appliance cool down.
13