Zanussi ZFC631WAP Gebruikershandleiding - Pagina 4
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZFC631WAP. Zanussi ZFC631WAP 12 pagina's. Chest
Ook voor Zanussi ZFC631WAP: Gebruikershandleiding (8 pagina's), Gebruikershandleiding (12 pagina's)
Pagina afdrukken
Operation
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise.
The Pilot light will light up.
The Alarm light will light up.
Switching off
To turn off the appliance, turn the Temperature regulator
to the OFF position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator towards
the minimum coldness.
• turn the Temperature regulator towards
the maximum coldness.
Control panel
5
1
Pilot light
2
High temperature alarm light
3
Fast Freezing light
4
Fast Freezing switch
Alarm reset switch
First use
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm water
and some neutral soap so as to remove the typical smell
of a brand-new product, then dry thoroughly.
4
to obtain
to obtain
1
2
3
4
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the lid is opened
• the quantity of food stored
• the location of the appliance.
5
Temperature regulator
Fast Freezing function
You can activate the Fast Freezing function by pressing
the Fast Freezing switch.
The Fast Freezing light will light up.
It is possible to deactivate the function at any time by
pressing the Fast Freezing switch. The Fast Freezing light
will switch off.
High temperature alarm
An increase in the temperature in the freezer (for example
due to an power failure) is indicated by switching on of
the Alarm light
During the alarm phase, don't place food inside the freez-
er.
When normal conditions are restored the Alarm light will
switch off automatically.
Important! Do not use detergents or abrasive powders,
as these will damage the finish.