Zanussi ZFT10210WV Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZFT10210WV. Zanussi ZFT10210WV 17 pagina's.

Zanussi ZFT10210WV Gebruikershandleiding
4
1
CAUTION! Reposition, level the
appliance, wait for at least four hours
and then connect it to the power
socket.
Do a final check to make sure that:
All screws are tightened.
The magnetic seal adheres to the
cabinet.
The door opens and closes
correctly.
If the ambient temperature is cold (i.e.
in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.
ELECTRICAL CONNECTION
CAUTION! Any electrical work
required to install this appliance
should be carried out by a qualified
electrician or competent person.
WARNING! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
The wires in the mains lead are coloured in
accordance with the following code:
12
2
3
A - green and yellow: Earth
C - brown: Live
D - blue: Neutral
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and yellow to
the terminal marked either with the letter "E" or
by the earth symbol
yellow.
2. Connect the wire coloured blue to the terminal
either marked with the letter "N" or coloured
black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or coloured
red.
4. Check that no cut, or stray strands of wire is
present and the cord clamp (E) is secure over
the outer sheath.
Make sure the electricity supply voltage is the
same as that indicated on the appliance rating
plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp fuse (B).
In the event of having to change the fuse in the plug
supplied, a 13 amp ASTA approved (BS 1362)
fuse must be used.
A
B
or coloured green and
WARNING! A cut off plug inserted
into a 13 amp socket is a serious
safety (shock) hazard. Ensure that it is
disposed of safely.
C
D
E