Zanussi ZRB38337XA Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZRB38337XA. Zanussi ZRB38337XA 44 pagina's.

Pagina afdrukken
Problem
The compressor does not start
immediately after pressing the
QuickChill, or after changing the
temperature.
Water flows on the rear plate of
the refrigerator.
Water flows inside the refrigera-
tor.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance
is too low/too high.
All the temperature setting LEDs
flash at the same time.
Closing the door
1. Clean the door gaskets.
www.zanussi.com
Possible cause
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost melts on the rear
plate.
The water outlet is clogged.
Food products prevent that water
flows into the water collector.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The or QuickChill function is
switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature
is too high.
Many food products are stored at
the same time.
The door has been opened often. Open the door only if necessary.
The QuickChill function is
switched on.
There is no cold air circulation in
the appliance.
An error has occurred in measur-
ing the temperature.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
The compressor starts after a pe-
riod of time.
This is correct.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Switch off or QuickChill manual-
ly, or wait until the function resets
automatically to set the tempera-
ture. Refer to " or QuickChill
function".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Refer to "QuickChill function".
Make sure that there is cold air
circulation in the appliance.
Contact the nearest Authorized
Service Centre. The cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possible.
"Installation".
gaskets. Contact the Service Center.
Solution
11