Zanussi ZHC 950 Instructieboekje - Pagina 16

Blader online of download pdf Instructieboekje voor {categorie_naam} Zanussi ZHC 950. Zanussi ZHC 950 21 pagina's. Zhc 950
Ook voor Zanussi ZHC 950: Installatie- en gebruikshandleiding (10 pagina's)

Pagina afdrukken
Extraction
The charcoal filter is not required in this mode
and should be removed.
Ducting
The ducting used must be Ø150mm (6ins), or
Ø125mm (5ins) in diameter.
If possible duct through the wall immediately
above the hood body.
For the best performance use the shortest
possible duct run and the minimum number of
bends.
Where flexible ducting is fitted it should not be
turned through very tight bends as this may
impair the performance of the hood.
It is recommenmded a maximum length of 3
metres, to be installed, to be reduced 1 metre for
o
each 90
bend installed in the ducting run.
If the distance is greater than 3 metres the
efficency of the hood could be impaired.
The diameter of the ducting spigot on the top of
the hood body item 1 is Ø150mm (6").
When using Ø125mm (5") ducting it will be
necessary to install the ducting adapter item 9 to
the Ø150mm (6") outlet on the top of the hood
body and the Ø120mm to 125mm ducting collar
item 3 (supplied).
If the room where the cooker hood is to
be used contains a fuel burning appliance
such as a central heating boiler, then its
flue must be of the room sealed or
balanced flue type.
If other types of flue or appliances are
fitted ensure that there is an adequate
supply of air to the room.
The cooker ducting (extraction mode)
must never be connected to central
heating flues, radiators or water heaters
etc.
Electrical Connection and Working
Test
Before fitting the chimney to the canopy make
the electrical connection as described in the
section titled "ELECTRICAL CONNECTION".
When the electrical connection has been made,
test the three speed fan and worktop
illumination.
14