Zanussi ZCV69360BA Gebruikershandleiding - Pagina 28
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZCV69360BA. Zanussi ZCV69360BA 33 pagina's.
Ook voor Zanussi ZCV69360BA: Gebruikershandleiding (32 pagina's)
Pagina afdrukken
WHAT TO DO IF...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
Residual heat indicator does
not come on.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Steam and condensation settle
on the food and in the cavity of
the oven.
There is no good cooking per-
formance using the Plus Steam
function.
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
28
Possible cause
The appliance is not connec-
ted to an electrical supply or it
is connected incorrectly.
The fuse is blown.
The zone is not hot because it
operated only for a short time.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The lamp is defective.
There was a power cut.
You left the dish in the oven for
too long.
You did not fill the cavity em-
bossment with water.
The temperature is too low.
There is to much water in the
cavity embossment.
the oven cavity. Do not remove the rating plate from
the oven cavity.
Remedy
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Replace the lamp.
Reset the clock.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
Refer to "Activating the Plus
Steam function".
Set the temperature at least to
110°C. Refer to "Hints and
Tips" chapter.
Deactivate the oven and make
sure that the appliance is cold.
Wipe the water with a cloth or
sponge. Add the correct
amount of water to the cavity
embossment. Refer to "Activat-
ing the Plus Steam function".