Zanussi ZE 942 Instructies voor gebruik en verzorging - Pagina 18
Blader online of download pdf Instructies voor gebruik en verzorging voor {categorie_naam} Zanussi ZE 942. Zanussi ZE 942 20 pagina's. Cooker
Ook voor Zanussi ZE 942: Instructies voor gebruik en verzorging (20 pagina's), Gebruiksaanwijzing (20 pagina's)
Pagina afdrukken
El
tri eal
It is therefore advisable, the first time the
ec
appliance is used, to pre-heat the oven for
about 30 mins. at peak temperature
e
connection
without putting any food into it.
The appliance is designed to operate on
alterning current, with a single phase
voltage of 240V - 50 Hz.
The electric supply cable has to be
connected to the terminal board placed
under the cover on the back of the
appliance. The oven terminal board has
the following markings:
L=Live
N= Neutral += Earth
The ground wire has to be green & yellow
coloured. If you require a direct connection
to the electric network (mains), it will be
necessary to fit between the cooker and
the mains an omnipole switch, with a
minimum aperture between contacts of
3 mm, suitable to carry the required load
and conforming to the ruling specifications.
The green & yellow ground wire must
not be interrupted by the switch.
The supply cable must at any rate be
placed in such a way as to ensure that
it does not reach at any given point a
temperature 50 °C higher than the
ambient temperature.
Prior to connecting the cooker to the
electricity supply make sure that:
the protection fuse and the domestic
wiring are suitable to carry the total
electric load of the cooker (see rating
plate):
the electricity supply network (mains) has
an efficient earth connection according
to the established rules and existing
regulations;
with the cooker definitely installed, the
wall socket'or the omnipole switch can
easily be reached.
The Manufacturer disclaims any liability
in case these accident-preventing rules are
not observed.
The heat insulation of the oven and grease
residues from the manufacturing process
produce smoke and an unpleasant smell
Ti the first minutes of operation.