Clarke SED14A100 Handleiding voor bediening en onderhoud - Pagina 7
Blader online of download pdf Handleiding voor bediening en onderhoud voor {categorie_naam} Clarke SED14A100. Clarke SED14A100 17 pagina's. 3hp direct drive compressor
Pagina afdrukken
OPERATION
1. Insert the mains plug into the mains socket and switch on the power.
• The mains voltage must be 230V.
2. Lift the red On/Off switch.
• The compressor will make a
continuous loud noise when the
tank is charging - this is normal.
• The compressor will charge the
main tank to 8 bar (116 psi) then
switch off.
• The compressor will restart
automatically whenever the
pressure in the main tank falls
below a certain level.
3. Check the safety valve daily by
pulling on the ring attached.
• Air should be released you pull
the ring and stop when
released.
• If the valve does not operate as
described, or if the valve is
stuck, it must be replaced by
qualified service personnel
before using the compressor.
WARNING: DO NOT REMOVE OR ATTEMPT TO ADJUST THE SAFETY VALVE.
4. Select the pressure you need using
the pressure regulator. (if fitted)
7