Clarke CDS1V Gebruiks- en onderhoudsinstructies - Pagina 6
Blader online of download pdf Gebruiks- en onderhoudsinstructies voor {categorie_naam} Clarke CDS1V. Clarke CDS1V 11 pagina's.
Ook voor Clarke CDS1V: Handleiding voor bediening en onderhoud (13 pagina's)
Pagina afdrukken
Operation
1.
Fitting Sanding Pad.
a) Select pad to be used. (MUST be correct pads with velcro fitting ability).
b) Ensure sander is switched OFF and plug is removed from socket.
c) Line up holes in pad with those on machine pad. (this is necessary for dust
extraction), press pad firmly onto machine pad to secure it.
2.
Dust Collection.
The dust collection bag/suction, (not supplied), is fitted to sander duct on sander
handgrip, below the mains cable.
Note :
If using a dust bag, it must be emptied regularly, do not wait until it is completely full.
To operate, plug into the mains supply then switch ON by sliding the switch, on top of the
unit, backwards. A speed selector wheel mounted behind the ON/OFF switch, allows the
sander to operate at speeds appropriate for the job in hand.
Offer sander to workpiece and work slowly backwards and forwards across the area to be
sanded until finished. Remove sander from workpiece and slide switch forwards to switch
OFF, (Wait until machine has stopped completely before putting it down.
Maintenance
Always inspect the tool before use, and ensure it is in top condition.
Ensure all air vents are clear, (use compressed air to clean the machine where possible).
Check the power cable to ensure it is sound and free from cracks, bare wires etc. avoid
using solvents when cleaning plastic parts, most plastics are susceptible to damage from
the various types of commercial solvents.
All bearings etc., in this tool are lubricated with a sufficient amount of high grade lubricant
for the tools lifetime under normal operating conditions, therefore no further lubrication is
required.
Trouble Shooting
Sander is overheating
This indicates the machine is dirty. Clean the ventilation holes, and blow out with compressed
air or clean with a dry cloth.
Overloading the machine will also cause overheating. Do not use for heavy duty work, and
do not apply excessive pressure.
Excessive sparking occurs
This indicates worn brushes. This problem is quickly remedied but you should consult your
CLARKE dealer for parts and advice.
Sander does not operate when switched ON
Check to ensure the fuse is sound and replace if necessary. If the fuse is sound or the blows
-6-