Aleko BSW08 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Aleko BSW08. Aleko BSW08 4 pagina's. Nest swing & glider

Nest Swing Assembly

(x4)

M8 BOLT 59mm (X1)

Step 1. Insert tapered end of Top Bar 1 into the end of Top Bar 2. Make sure there

is only 1 set of holes in the end connected to Top Bar 1.

Step 2. Use 1 F2 fastener to connect Top Bar 1 to Top Bar 2

**Always Make sure to place included washers between fastener head or nut

and adjoining swing components**

Step 3. Insert 1 Top Leg segment into either side of the T-shaped Connector,

secure with 2 F3 fasteners per Leg. Repeat for both Connector and Top Legs

assemblies.

Step 4. Insert either end of assembled Top Bar into Connecter and Leg Assemblies.

Use 2 F5 fasteners on each side to attach.

(x4)

Fig. 1

M8 BOLT 65mm (X4)

Attach Swing to Assembled Frame

Step 1. Completely disassemble F1 U-Bolts then place u-shaped bolt through the

hole in the bearing assembly found at the end of the Swing ropes.

Step 2. Tighten open-ended F1 nut down onto u-shaped bolt, place 1 F1 washer on

each end of the bolt and insert into Top Bar through 2 sets of vertical holes. Ensure

washer placement between nuts and Top Bar.

Step 3. Place 1 F1 washer on the exposed threaded ends of the F1 bolt, then attach

F1 cap nuts and tighten down. Repeat for both sets of Swing ropes.

Attach Bottom Legs and Side Stay Bar

M6 BOLT 52mm (X12)

Step 1. Insert 1 Bottom Leg into the open end of each of the 4 Top Legs. Place

a F3 fastener into each of the holes at the junction, making sure the exposed

threaded end is pointed away from the Nest Swing (Fig. 1).

Step 2.Place Side Stay Bar over the exposed fastener ends so that the flat side

of the Stay Bar ends is in contact with the Top/Lower Leg assembly (Fig 1).

Step 3. Tighten F3 nut down onto Side Stay Bar.