Clarke Super 7R Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Clarke Super 7R. Clarke Super 7R 16 pagina's. Dc edger
Ook voor Clarke Super 7R: Gebruikershandleiding (17 pagina's), Bediening en veiligheid (2 pagina's), Handmatig (6 pagina's)

Pagina afdrukken

ADJUSTMENT PROCEDURES

Leveling

To level machine: Grasp caster adjusting screw "A" with an

appropriate tool (pliers ect.). Using a similar tool, loosen

locknut "B" with a counter clockwise motion. (Figure 4).

Condition - Pad creates ridges on both edges or a "hop" is

experienced: Rotate both adjusting screws equal amounts

clockwise. Tighten locknuts and test on a piece of ply-

wood. Repeat procedure until condition is corrected. We

recommend you not exceed 1/8" rotation for each attempt.

Condition - Pad creates a ridge on the tip of the pad:

Rotate both adjusting screws counter clockwise, tighten

locknuts and test. Repeat procedure until condition is

corrected. Use only 1/8 rotation for each attempt.

Condition - Pad creates a ridge on only one side of the pad:

Either rotate the adjusting screw of the side effected

clockwise or rotate theadjusting screw opposite counter-

clockwise, depending on whether the ridge terminates

beyond the tip of the pad or prior to it. If it is prior to the

tip, adjust the side effected, otherwise adjust the opposite

side.

ROUTINE MAINTENANCE

CAUTION: Failure to perform maintenance at

recommended intervals may void

warranty.

Carbon Brushes

Have the carbon brushes replaced at least every 500

hours and more frequently under heavy use.

Dust Bag

Periodically the dust bag should be turned inside out,

shaken vigorously and machine washed in cold water

to prevent pore blockage and loss of dust control.

Bearings

To insure reliable performance, have armature and pad

driver bearings inspected for wear or damage after every

1500 hours. If used heavily, have the bearings replaced

seasonally.

Lubrication

The machine comes fully lubricated. The gears in the

gear box have enough lubrication for approximately six

months of normal operation. Have the lubricant changed

at least every 6 months or more frequently under heavy

use.

Clarke

American Sanders Super 7R Operator's Manual

Figure 4

Page 9