Clarke 7230102 Handleiding voor bediening en onderhoud - Pagina 7
Blader online of download pdf Handleiding voor bediening en onderhoud voor {categorie_naam} Clarke 7230102. Clarke 7230102 13 pagina's. Submersible dirty water pump
Pagina afdrukken
OVERLOAD SWITCH
These pumps are fitted with a thermal overload switch. If the pump overheats
for any reason, it will automatically switch the pump OFF. Once the pump has
cooled (at least 5-10 minutes), the pump will automatically restart.
MAINTENANCE
WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT
IS UNPLUGGED FROM THE ELECTRICAL SUPPLY. IF THE UNIT IS HARD WIRED,
ENSURE THE CIRCUIT BREAKER IS OPEN.
This pump should require no maintenance other than regular cleaning.
If the pump starts to show signs of wear or damage, contact your CLARKE
dealer for advice.
CLEANING
1. Check the pump installation regularly to ensure the water inlet is clear of
leaves or other debris.
2. Take extra care to remove any debris from around the impeller.
NOTE: Do not attempt to repair the pump yourself. Repairs must be carried
out by your CLARKE dealer, or contact the CLARKE Service
Department.
STORAGE
When the pump is not being used for extended periods, clean and dry it
thoroughly and stored indoors. if the pump is left in water, it must be run at
least once a week to prevent it from seizing up.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7