Alemite 7889-6 Servicehandleiding - Pagina 13

Blader online of download pdf Servicehandleiding voor {categorie_naam} Alemite 7889-6. Alemite 7889-6 14 pagina's. High-pressure material pump

High-Pressure Material Pump

11. Slowly supply air pressure to the pump's motor.

12. Allow the pump to cycle slowly until the product is

once again free of air.

13. Set the air pressure to 100 psi (6.9 Bar).

14. Operate the control valve into the container

momentarily.

15. Shut off the control valve.

• Visually inspect the pump for external leaks.

• The pump should not cycle more than once or

twice in one hour.

If the pump does not stall, refer to the

Troubleshooting Chart for details.

16. Check the motor for air leakage.

If the motor leaks, refer to the Air Motor Service

Guide for details.

IMPORTANT: Make sure to reset the air

pressure to the required operating pres-

sure.

Alemite Corporation

Installation

Additional items that should be incorporated into the air

piping systems are listed in Table 5.

Part Number

338862

Moisture Separator/Regulator & Gauge Combination

5608-2

Moisture Separator

7608-B

Regulator and Gauge

5908-2

Lubricator *

Table 5 Air Line Components

* Although the air motor is lubricated at the factory, the

life of the motor can be extended with the use of a lubricator.

SER 7889-6

Description

Revision (3-03)