Acora Acoustics SRB Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Acora Acoustics SRB. Acora Acoustics SRB 8 pagina's. Standmount speaker

Unpacking and Initial Placement

Each Acora Acoustics loudspeaker has been inspected and packaged with pride.

Please verify that both boxes are in good condition and the serial numbers are

consecutive.

Please use extra caution when unpacking the SRB alone. Have your dealer or consultant

perform or at least assist with this process. The SRB is heavy and should not be moved

without qualified assistance.

1) Remove the speaker from the carton by removing the 4 clips on the lower edge of the

carton (see below), then lifting the top straight up.

2) With the top removed you can now pick up the SRB up by positioning your fingers

under the speaker at the sides and lifting it out of the bottom tray.

(Use caution not to grasp the speaker near the drivers or the terminals as you could damage them.)

3) Visually inspect the speaker for any transit damage.

4) The SRB is designed as a standmount speaker. Please ensure that your stands are

designed to support 60+ pounds, are 25" to 30" from floor to supporting base (depending

on height of listening position) and are level. Supporting base should be at least 6" x

6" square to support the SRB. A small dab of reusable adhesive putty or doublestick

adhesive is recommended to keep the SRB from sliding off the base and to couple the

speaker to the stand.

For initial positioning, place the speakers parallel to the rear wall, roughly the same

distance between them as they are to the main listening position (if you sit 12' back from

them, start with the speakers 12' apart if possible unless side walls prevent it) Typically,

the speakers will image best when not towed in.

6) Connect your speakers to your amplifier and perform initial listening tests. This very well

may not be their final position. (See page 4)

7) After you believe you have final placement, re-check that the stands (and speakers) are

level.

8) Retain shipping carton for future use.

Listen and enjoy. You may find over time that you want to re-adjust speaker placement,

again, please do not attempt this alone.

1) Pinch the two vertical ribs so the bottom

swings out from the base.

2 Swing the paddle up and pull entire clip

out when it becomes free.

3) Save these clips for future use