Alemite 9911-HC1 Servicehandleiding - Pagina 4

Blader online of download pdf Servicehandleiding voor {categorie_naam} Alemite 9911-HC1. Alemite 9911-HC1 4 pagina's. High-pressure portable pump

Pagina afdrukken

SER 9911-HA1

Assembly

NOTE: Refer to Figure 2 for component

identification on all assembly procedures.

CAUTION

Select a clean environment for all assembly pro-

cedures. Prevent contamination from foreign

material. Damage to components can occur.

Pump Assembly

IMPORTANT: Make sure to remove the

protective cover from the inlet of Pump

Assembly (1).

1. Screw Bung Adapter (4) into Cover (5).

2. Install Pump Assembly (1) into the Bung Adapter.

• Do not tighten the Bung Adapter at this time.

Cover Assembly

NOTE: The following procedures are

applicable to model 9911-HA1 only.

3. Install Grip (16) onto Handle (15).

4. Screw Nut (12) onto each end of the Handle.

5. Install the ends of the Handle into the Cover.

6. Install Lock Washer (13) and additional Nut (12)

onto each end of the Handle.

• Tighten the Nuts securely.

Revision (8-02)

10. Adjust the Pump upward approximately 1/4 "

11. Tighten the screw on the Bung Adapter securely.

12. Screw the large diameter end of Adapter (2) [with thread

13. Screw either end of Material Hose (3) into the Adapter.

14. Screw the 1/2 " -27 end of Z-Swivel (18) [with thread

15. Screw the opposite end of the Z-Swivel [with thread

16. Test/Prime the Pump assembly.

Changes Since Last Printing

Changed Bung Adapter from 326750-F1 to 326750

High-Pressure Portable Pump

Follower Plate Assembly

7. Place Follower Plate (9) onto the top of the product.

• With a wobbling motion, eliminate any air that may be

trapped underneath the Follower Plate. Force the

product through the hole in the center of the Plate.

8. Guide the Pump and Cover Assembly into the Follower

Plate and fit the Cover onto the container.

• Allow the Pump to descend to the bottom of the

container.

9. Secure the Cover to the container with Thumb

Screws (8).

(7 mm) from the bottom of the container.

• Make sure the pump is oriented properly.

Control Valve and Material Hose

IMPORTANT: Do not apply thread sealant to

the first two (2) threads of any connection.

Contamination can occur.

sealant] into the outlet of the Pump Assembly.

• Tighten securely.

sealant] into the Material Hose.

• Tighten securely.

sealant] into Control Valve (17).

• Tighten securely.

• Refer to Service Guide SER 9911-1/9950-1 for details.

Alemite Corporation