Directed Electronics PS-3655E-FM Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Directed Electronics PS-3655E-FM. Directed Electronics PS-3655E-FM 16 pagina's. One-way fm automatic / manual transmission remote starter

Directed Electronics PS-3655E-FM Gebruikershandleiding
If your vehicle has an automatic transmission and it does not start at the first attempt, the system
will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts
before the system gives up.

Driving Off

With the vehicle running remotely, press the
vehicle and do the following:
Turn the ignition key to the
IGNITION ON (RUN)
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.

Remote Starter Features

Remote Door Locks

If your system was installed with the Remote Door Locks option, you will have the convenience of
remote keyless entry.
To lock your doors and arm the starter kill (if installed):
1.
Press and hold the
button for approx. 1 sec.
2.
The parking lights will flash once to confirm that the doors have been locked
To unlock your doors and disarm the starter kill (if installed):
1.
Press and hold the
button for approx. 1 sec.
2.
The parking lights will flash twice to confirm that the doors have been unlocked.

Remote Trunk Release

If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
button for 3 seconds on the remote transmitter. In addition, this will also disarm
the OEM style alarm.

Idle Mode

Convenience feature: Idle Mode allows you to keep the engine running and the doors locked
while you stop, for example, at a convenience store or for a short delivery
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
If your vehicle has an automatic transmission, proceed as follows to set the system to Idle Mode:
1.
With the engine running, make sure to release the brake pedal and press the
button on the transmitter until the parking lights come ON.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
button to lock the doors, to arm the starter kill and to arm the OEM style
alarm.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode (page-6); at the last step, press
the system and leave the engine running.
User guide
button to disarm and unlock the doors. Enter the
position. (Do not turn the key to the
CRANK
button to lock the doors, arm
position
,
or
P.7