Clarke 59231A Bedieningshandleiding en onderdelenlijst - Pagina 5

Blader online of download pdf Bedieningshandleiding en onderdelenlijst voor {categorie_naam} Clarke 59231A. Clarke 59231A 12 pagina's.

How To Operate The 8" and 12" Wands

NOTE:

Instructions for preparation and

operation of your extractor are given

with the extractor.

CAUTION: Clarke will not be held liable for

damage to the carpet, or poor results

because of operator's lack of train-

ing.

CAUTION: Do not use water that is hotter

then 140°F.

To operate the 8" and 12" wands follow this proce-

dure:

1. Connect the vacuum hose to the hose con-

nector on the extractor and to the end of the

vacuum tube on the ﬂ oor.

2. Connect the solution hose to the extractor

and the ﬂ oor tool. To fasten the quick-dis-

connect slide the knurled collar on the female

coupling away from the opening. Push the

male coupling into the female coupling.

3. The switch that activates the motor for the

pump is on the extractor. Put the switch in

the "ON" position.

4. The switch that activates the motor for the

vacuum is on the extractor. Put the switch in

the "ON" position.

5. Move the ﬂ oor tool to the right-hand corner of

the carpet.

6. Hold the ﬂ oor tool at an angel that gives the

best seal between the tool to increase the

seal.

7. Press down on the tool to increase the seal.

8. Press the solution release lever.

9. Move backwards and pull the tool toward you

at a rate of about 30 feet per minute. Move

slower for very dirty areas.

10. Release the solution lever approximately six

inches before you stop moving backward.

11. Lift the wand and move it to the side of the

starting point.

12. To clean the edge of a room, move the wand

along the baseboard.

CLARKE Extractor Tools Operator's Manual

FORM NO. 79042A - 5